smartVES – programming and operation
Setting of the Basic Configuration section
Selector software hardware system requirements and installation
Network card configuration
Configuration of the logic output card
Configuration of the logic inputs card
ABT-xCtrLine-44 – 4 loudspeaker lines control card – configuration
ABT-xCtrLine-4 – 4 loudspeaker lines control card – configuration
Configuration of the Priority manager
ABT DMS microphone configuration
Control I O configuration
Replacing and adding devices in the system
Configuration of the “Zone group configuration” section
Connection with 100 V internal buses using ABT-CU-11LT / ABT-CU-11LCD
Individual connection with backup amplifier using ABT-CU-11LT / ABT-CU-11LCD
Downloading the configuration from VES to the PC
Setting up NSC6 and NSM – Noise Sensing Controller and Noise Sensing Microphones
ABT DFMS microphone configuration
smartVES – DU1604 and AMAP-6 – config and calibration
Configuration of the DMS-LCD microphone
Selector Software – System Notifications
Connection to the VES unit
